PLASTER SPRAYER KOMPAKTA 1-220 Volt
Specification for material "from coat".
| DIMENSIONS |
| Width |
65 cm |
| Length |
68 cm |
| Height |
145 cm |
| Weight |
127 kg |
| Tank capacity |
60 lt |
|
| 1 | Extraction system from the mixing chamber for a perfect inside washing, since the materials inside, which are normally used for the "cappotto" coatings, are quite aggressive and sticky. The chamber has futhermore an inner lining made of sultably thick rubber layer. |
| 2 | Turbo system which enables to re-mix the products' that have to be inflated (termo-plastering) by alt, or products containing a small amount of aggregates. |
| 3 | Wire for the stop-start control, with turns regulator |
| 4 | Gun for leak in the material |
| No. 3 and no. 4 for leak in material or injections or support for the glue on the panel. |
|
|
| EQUIPMENT |
| 15 mt. pipe |
| Mortar gun |
| Water plant |
| Compressor |
| Voltage extension |
| Gun for leak in the material |
|
|
| HEAD |
| 10 mt. |
| Max. 30 mt. distance |
|
|
| PERFORMANCE |
From 0 to 20 lt min/max
according to the kind of material |
|
|
| GRANULOMETRY |
| From 0 to 6 mm |
|
|
Turbo system which enables to re-mix the products' that
have to be inflated (thermo-plastering) by air, or products
containing a small amount of aggregates.
Patended system with no return thrust effect. It always warrants a regular thrust towards the stator; since the machinery pushes dry material in horizontal position. Moreover the system allowes the same thrust with strong different type of material usage.
